Rong-fu (round column) mills
"Jim Wilkins" wrote in message
...
On Dec 18, 12:23 am, "Michael Koblic" wrote:
I was looking at a Rong-Fu clone today (RF30). ...
Michael Koblic
I used one for a while and wasn't highly impressed, 0.5mm accuracy was
about its limit. The quill was tilted, the table grooves had been
milled at an angle and the fine downfeed was almost impossible to
adjust closer than 0.005" because it shifted when locked.
That sounds like a Rong-Wae. g
--
Ed Huntress
|