"Edwin Pawlowski" wrote in message
...

"Mike O." wrote in message

Based on my expected usage, features, price, etc. I'm looking at
either the Ryobi TS1551DXL or Rigid MS1250LZ from Home Depot.

The first question I have whether both units will cut 4x4's? The
Ryobi specs say it can, but from Rigid's site, it lists the capacity
as 2x8. I would think pretty much any 12" miter saw would be able to
handle it. The 10" Rigid model lists as working with 4x4's, but only
on a 90 degree cut. There have been times I've needed an angled cut
in a 4x4, and if I'm going to spend the money for a saw, I figure I
might as well go for something that can handle anything I'm likely to
need.
Even though it costs more, I'm leaning toward the Rigid one based on
the solid appearance of the unit, and it includes a floor stand.
Also, they're offering a lifetime warranty if purchased by Dec 31.


I looked at those also, but bought a DeWalt. It will cut up to a 4 x 6 @
90
degrees. I don't know about on an angle, but it can be done with two
cuts.

I have seen some negative comments on Ryobi quality, but I've had a
Ryobi 10" drill press and have been happy with it.

Ryobi is light weight. For most homeowners with occasional use, it is OK.
For a contractor that uses the tools every day, it is not going to hold
up.
The Ridgid is a bit better, but don't let the lifetime warranty lull you
into a sense of security. It is for manufacturing defects only so normal
wear is not covered. The DeWalt is about $300. Only you can determine if
the better quality is worth the extra $.
Ed



Thanks for the comments.

I looked at the Dewalt; it's about the same price as the Rigid, but it
doesn't look like it includes the clamp and stand. I realize I can add
those, but it's that much more cost.

As far as the Ryobi, I'm seeing more and more of the same type of comments
(light weight). As I said, I'm probably not going to be heavily using it
daily, but at the same time I want something that will hold up for a long
time.

-Mike O.