Have you tried it the other way ? Start from the taper and work into the
flute .
Jim
"GarageWoodworks" wrote in message
...
On Nov 21, 5:10 pm, "Leon" wrote:
"GarageWoodworks" wrote in message
...
Ok, I tried making a few stopped flutes which terminate with a taper
using a wedge as discussed in a previous thread. (Suggested by
SonomaProducts)
Here is the result:
http://www.garagewoodworks.com/shop_talk.php
Came out ok. You can definitely see where the taper begins in the
flute (not a completely smooth transition). This can probably be
fixed with a piece of sandpaper or just leaving it alone.
IMHO the stopped end looks better with out the taper. And you don't have
the shutter as the router changes direction.
I have an example on a.b.p.w.
I appreciate your candor Leon. It is difficult to control/prevent the
shutter. As the base fist hits the wedge (which is knife sharp) it
stops and then climbs. This is mirrored in the flute. You can see a
tiny 'step' in the bottom of the flute before it transitions to the
climb up. I was able to make the step less noticeable with sandpaper
by curling it into a radius that complements the flute. Not sure what
I will do yet. The neander method of using a gauge might look nicer,
but I dont own any gauges. :^|