Thread
:
Fitting stainless steel insect mesh into door
View Single Post
#
3
Posted to uk.d-i-y
Tim[_25_]
external usenet poster
Posts: 2
Fitting stainless steel insect mesh into door
"Tim" no
wrote in message
. ..
Hi
I need some advice on the best way to fit stainless steel insect mesh
into a softwood timber door. The door is a two panel design and the mesh
is going in the top panel.
Size of opening is 430 x 1285mm with a 35 wide x 15mm deep rebate to fit
the panel of mesh in.
The mesh spec is, Stainless Woven Wire Mesh Size 16 mesh - 1.2 mm
aperture
I'd like to stretch the mesh like a canvas to get it taught and flat but
haven't a clue how to do it in a way that can be hidden in a rebate that
size. Has anyone done something like this before?
The insect mesh on our camper door (fabric, not stainless) is stretched by
pushing a round rubber strip into a channel all round the edge.
This both tensions and holds the mesh.
This might work with a very flexible and light steel mesh.
Alternatively you could decide to use a heavier weight of steel mesh so
that it is rigid and doesn't need stretching, in which case I assume you
would fit it just like a pane of glass.
Cheers
Dave R
Thanks Dave that's given me a couple of ideas.
Cheers
Tim
Reply With Quote
Tim[_25_]
View Public Profile
Find all posts by Tim[_25_]