Perry (News) wrote:
I'm replacing the worktops in our utility room which, in itself, isn't
a problem as it's a nice, rectangular shape with worktops down two
sides, but I need a mitred right-angle join - I've never cut one of
these before and understand that it's a bit of a steep learning curve
for a one-off job, so I wondered if anyone knows anywhere around the
Worthing/Brighton area that will sell a worktop pre-mitred and routed
for the butterfly bolts

Hard to see how that can happen as worktops are essentially bespoke for
their application - the lengths of the 'L's are infinitely variable when
you think about it. Apart from that, you can guarantee that if you were
able to buy one with the slots for the butterfly bolts pre-routed, they
would coincide with the position of struts etc in the units below
preventing access.

If you don't want to diy the obvious solution is just to hire a kitchen
fitter/joiner to fit the worktops (as I've done myself in the past).

David