In article
,
Adam Aglionby wrote:
On 22 Oct, 17:32, "Dave Plowman (News)" wrote:
Bought some Bulgin Buccaneer IP68 rated connectors. The chassis mount
one has a rubber gasket between it and the chassis and is secured by
four screws. There are four 'top hat' bushes supplied also with the
same hole size as both the fitting and gasket - but no information on
how they're used. Looked at the PDF on the Rapid site - no clue there.
They're not even shown. Any guesses?

Bulgins own PDF refers to them as Screw sealing grommets, guess to
seal under screwhead stop wicking through panel.

http://www.bulgin.co.uk/PDFs/CatNo82...ndard_2005.pdf

Right. Didn't find that PDF on the Rapid site - they weren't mentioned in
the panel mount specific one. But they don't appear to fit in the flange
holes so I'm slightly confused about how to fit them?

The locking rings dont survive being dropped very far...

Oh dear. Hopefully it will get light and careful use.

--
*What was the best thing before sliced bread? *

Dave Plowman London SW
To e-mail, change noise into sound.