Ignoramus19639 wrote:
I have replaced the old bearings with new double sealed ones from
McMaster. (made me very glad to have this 12 ton arbor press).

After reassembly, but without any wheels mounted, the grinder runs
very quietly and very smoothly. The shafts do not appear to vibrate at
all. Ie, I can put my finger to the shaft rotating at 3600 RPM, and I
would feel no vibration from it whatsoever. It would feel like pulling
a finger along a flat smooth piece of metal.

However, I if mount those wheels back, they seem to be not
perpendicular to their axis of rotation and make figure eights and
vibrate badly.

I have a feeling that I am not mounting them right.

i


The wheels most likely need balancing and trueing up ,even new wheels
need to have this done.
Also make sure they are a good fit on the shaft , you may need to put
bushes in the bore of the wheels to take up any difference between the
wheels and the shaft.Most new wheels come with a stacked set of plastic
bushes .

Make sure that the mounting /clamping washers are the same size
(diameter) each side and that there is some type of paper between the
washer and the wheel . Most wheels have this attached ,it's like
blotting paper.

--
Kevin (Bluey)
"I'm not young enough to know everything."