Generator to power MIG welder
"Jud" wrote in message
...
Hi all - I haven't been here in a long time, but remember this to be
one of the most knowledgeable groups about all things metal...
I need to be able to power a small MIG welder (Lincoln SP-100T) with a
generator, but don't know enough about voltage, watts, etc to know
what size I need. It won't be continuous use, mostly spot welds or
joints that would require no more than 60 seconds of welding. This is
for an on-site found object metal sculpture.
Any help is greatly appreciated.
- Jud Turner
If you plug the welder directly into the generator a 20 amp 120 volt outlet
will run a SP100 for light welding.
Steve
|