On Oct 5, 8:21*pm, "
wrote:
Seems to me that this is job for a router table.
Need to put a groove down the length of a small (less than 3 feet)
2x4. Was thinking I could do this by hand. It's a small groove. Not
more than 3/8 of a inch or so and only about 1/2 deep.
Thoughts, recommendations?
You could do it with a circular saw and a sawboard. With the right
blade you can get excellent results and it pretty much eliminates
splintering. You'd just have to take a couple of passes and move the
sawboard a bit for the second cut.
http://www.rochesterwoodworkers.org/...r/Sawboard.pdf
R