Mr Sandman wrote:
Will one of these -

http://www.kiowa.co.uk/Products/Quic...2_System).html


fit one of these -

http://www.screwfix.com/prods/21289/...OSFEY?ts=03906


if i take the compression nut off?

Yup should be fine. Much the same as fitting flex tap tails to the end
of a service valve. If you can't get a decent seal on the end of the
valve (unlikely IME), then you can always get a seal on the thread using
PTFE or fernox LS-X

--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/