"Markndawoods" wrote in message
. ..
Shelves of 3/4 ply, need to have dividers every 2"

The supply store did not have anything like traditional 1/4 HB for the
dividers, I ended up buying some 3/16 ply to use. Maybe a mistake.

How would you cut a 3/16 groove in the 3/4 boards? (I need them every 2",
making a total of 32 slots)

My sawblade is 1/8, my smallest router bit is 1/4 sigh

Suggestions please!

markndawoods


Make your slots 1/8" wide with your blade. Them with a straight router bit
shave 1/16" off of one side of the 3/16" plywood the depth of your slot.

I do this all the time, did it last week to make a so called 1/4" plywood
panel fit in a tight slot.

Or use a 1/6" spacer between your work and the fence. Make a pass, remove
the spacer and make the pass again.
Plastic laminate will probably work.