Thanks Tom,
I am in Berwyn, just south of Oak Park, not too far from Lake Forest. I am
using the Maggi Steff 2048 feeder on a Grizzley 3 HP shaper. I am available at
any time. I can either come to your site if you have a shaper and feeder set up
there, or you can come here if that would work out better. The drive is a
little less than 40 miles and probably an hour's drive.
Looking forward to it !
Thanks,
Matt

Tom Plamann wrote:

"Matt Zach" wrote in message
...
I need a little help getting started with a new shaper and power feeder
that I just purchased. I'm in the Chicago area, and hope to find someone
who can show me how to run my new shaper...
-.snip
So... is there either a woodworking group, and individual, or even a
small company in the greater Chicago area that might be willing to show
me how to use the shaper, either at my place or theirs? I'd be very
grateful, and would be glad to treat them to a good steak and a couple
of beers afterwards.
If there is a woodworkers club in the Chicago area, I'd like to find out
how to get involved in that also.
Thanks in advance (once again),
Matt


Matt

What part of Chicago are you on? I am designing a home in Lake Forest right
now and come down there once a week.

Tom Plamann
www.plamann.com