DIYbanter - View Single Post - Splice together 2 x 4's for storage shed?

(Rob) wrote in message . com...
I am building an 8'x10' storage shed from mostly scrap materials for $$ reasons.
I need to construct side walls 7' high using 2'x4's that are 3'- 4' in length.
Is it safe? If so, how should I do it? Mending plates, kerf cuts?

Rob

Rob, Ignore the naysayers. You can splice the 2x4's by using scrap
1/2" ply or osb wall/roof sheathing. Glue and nail. Scraps are
plentiful at job sites. Plenty safe if you butt the 2x4's tightly
together so that the load is transfered without relying on the patch.
Make up the studs first then cut to length as you normally would. You
can also use the short lengths with ply to make yourself 3 roof
trusses. A good way to recycle. Go for it.

mike