Circular Hole in a Bottle
On Sep 14, 1:31�am, RubEric wrote:
I wish to cut a round disk out of several wine bottles. �The bottle
has an etched figure I wish to remove for another purpose. �I have a
virtually unlimited supply of these bottles and they have no value so
I can afford to make mistakes.
How should I go about cutting a 2 inch diameter disk out of a bottle?
I had thought to use a diamond blade on my Ziptool to cut out a
rectangle and then wet grind the removed piece.
A diamond hole saw may be a possibility, but they are EXPENSIVE.
What would you suggest?
Thanks, Eric
I would take it to a glass shop and have them do it. I doubt they
would charge much. Call around and check them out. They could probably
do it for less money than it is going to cost you for a glass cutter.
Or, at least they can advise you better.
Hank
|