Dave Plowman (News) wrote:
In article ,
Dave wrote:
Dave Plowman (News) wrote:
In article ,
Dave wrote:
Shortly, I will have to remove the power shower unit from the
bathroom wall. Though I can remove the fuse that feeds it, what do I
have to do with the 3 cores coming out of the wall to make it safe?
Switch off the CU and remove the cover. Disconnect the cable
completely. You can tape up the ends and leave inside the CU in case
it's needed later.

Do something similar at the other end if you can - you just never
know.

I am hoping that I can put back the same power shower pump if I can
repair it, but it might well be off the tiled wall for some time.

John's idea sounds good, further down. By the way, the shower is tapped
off the upstairs ring to a fuse and isolating switch in the airing
cupboard before going under the bathroom floor and up the wall behind
the plaster and tiles.

Ah - it's a pump.

Pump, mixer, temperature and flow control. (Mirage Powerforce)

Thanks.

Dave