On Sun, 16 Aug 2009 20:55:15 +0100, Steve Walker wrote:

gunsmith wrote:
On 16 Aug, 20:06, seani wrote:
We've just had a slate floor put down in a small cloakroom and the
plumber is back to refit the toilet in a different position tomorrow.

I've tried it in the proposed position but notice the pan is likely to
end up with a very slight wobble if nothing else is used other than
the original screws when it's fixed to the floor. What solution should
I be checking for to make sure it's a good fix with no gap / rattling
etc?

Huge dollop of firm setting mastic perhaps.

I'd go for a bead/bed of polyester resin (screwfix 16539) for maximum
strength & stability, covered later by a smear of silicone for appearance.

Are you sure you don't mean 23386?