Posted to rec.crafts.metalworking
|
|
Gasket Cutter Photos
Thanks Pete - that looks handy!
Martin
Pete Keillor wrote:
I made this little cutter to make the spindle gasket for my Hardinge
TM, which is finally going back together. It uses No. 11 X-acto
blades. I may add a dowel for the slot in the blade, but maybe not.
It worked fine on a cutter mat. The pivot is a hand ground point on a
set screw locked by a second set screw.
http://metalworking.com/dropbox/GasketCutter.txt
http://metalworking.com/dropbox/GasketCutter01.JPG
http://metalworking.com/dropbox/GasketCutter02.JPG
Pete Keillor
|