On 2009-07-28, Ignoramus9483 wrote:
Does anyone have any idea what this is?
http://igor.chudov.com/misc/ebay/tmp/tmp-5284.jpg
http://igor.chudov.com/misc/ebay/tmp/tmp-5285.jpg
http://igor.chudov.com/misc/ebay/tmp/tmp-5286.jpg
Looks to me to be a fixture for sharpening end mills and
conventional mills. You do need a tool and cutter grinder to go with
it. It looks to be an earlier design, as later ones use air bearings to
allow the spindle to move. The finger of flat stock is used to support
the edge of the cutter as it slides past the grinder wheel.
Enjoy,
DoN.
--
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---