Trimming the corners
"Puckdropper" puckdropper(at)yahoo(dot)com wrote in message
...
I'm working on building a gate, and cutting mortises for the slats with a
1/2" bit in the router. The slats are also 1/2".
If I trim the corners using my trusty pocket knife, I tend to get a
shallow
cut at the top and a deeper cut at the bottom. Using the router (a
router/shaper really) seemed to do the rounding job quite well, but left a
lot of fuzz behind.
Does anyone have any recommendations on what to use to trim the corners?
Finish Sander?
|