On Jul 5, 4:40*pm, John E. wrote:
I have been asked to offer an opinion in a sensitive situation.

A machinist moved his shop across town and required some rewiring (3-phase
outlets, conduit, etc.) in order to locate some machines where he wanted
them.

He hires a guy who's not a pro (and later discovers is not insured) but has
done shop wiring before and had a good attitude and track record. The guy
does good work. No complaints about the quality of his work.

Owner throws the switch, all works fine.

The story continues 4 weeks later when the very expensive CNC fries its
controller PCB to the tune of $4000.

Turns out the voltage in the shop was upward of 245 and the taps in the CNC's
power supply were set for 220.

What is the legal and moral responsibility of each party?

What will not be helpful are replies about the character or intelligence of
either of the players or their actions.

Thanks.
--
John English

Tempting as it is to blame your Mr Bush for all the eveils of the
world, including my hens not laying, I would propose the following:
1.As noted, the main supply voltage is nominal, variations are normal
and to be expected.
2.Possibly, if the machine was let stand for a while in the unpowered
position, and it was an old controller (and with a linear power
supply, it probably was,) then the electrolytics in the power supply
could have failed due high ESR, and then it lost regulation and fried
the board.
3.My humble opinion is to just mark write it off to bad luck.
Otherwise, get the lawyers involved for years and huge amounts of
money......

Andrew VK3BFA