Sam Goldwasser wrote in message
...
This type is usually dark gray and soft - about the consistency of a
pencil
eraser, maybe a bit tougher. It can be removed laboriously with knives,
picks, and elbow grease. But the question is whether there is some easier
way to do this that would leave the underlying components undamaged.
This stuff is used in a variety of places including PCBs and laser
tube assemblies. Both of these are of interest to me. Modest heat
has no effect including immersing in boiling water - it's not hot-melt
glue.
Thanks!
--
sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html
Important: Anything sent to the email address in the message header above
is
ignored unless my full name AND either lasers or electronics is included
in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
I seem to remember using a 1/8 inch ball mill in a Dremmel for that sort of
stuff, localised heat and tugging action hepled in removing from surfaces,
.. But still time consuming and you have to know there is no little vital
stuff buiried within it.
--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/