On Sat, 20 Jun 2009 13:56:35 -0400, Ned Simmons wrote:

I'm trying to improve the dust collection on my surface grinder


As Andrew says and Karl almost says, look into putting some guards around the
table and running wet. The only time you need dust extraction is when dressing
a wheel really aggressively. The rest of the time, the coolant sweeps the
fines up and dumps them in your coolant clarifier. You also get less "sucking
up" of the work because it's kept nice and cool.

If you have to stick with running dry, the main thing is to put the hood where
the grit is going to be thrown into it already, without any help from the
suction. The grit is coming off at 60mph. Anything you do with airflow is only
going to help once the grit is already in the pipe. So have a hood that has
steep enough angles that the grit won't bounce out and have it located so that
it's almost touching the work. Then move the air through the pipes to keep the
grit heading towards the cyclone.


Mark Rand(don't have any dust extraction on the surface grinder, just coolant)
RTFM