Bending aluminium bar
On 18 June, 20:28, "R" wrote:
"Vet Tech" wrote in message
...
I have a length of 10mm diam aluminium bar that I'd like to bend into
a hook shape. Is this feasible using heat from a gas brazing torch or
is it a No No??
Yep.
Old trick we used at school was to wipe ordinary soap along the bar.
Heat until the soap *just* starts to smoke and bend as required.
Ok, sounds good but 2 questions arise:-
1. Would that be bar soap or liquid detergent?
2. Should I quench with water when the required shape is achieved?
VT
|