On 2009-06-09, Bob Engelhardt wrote:
DoN. Nichols wrote:
... heat shrink fitting the webs to the pins in a big stack. ...

That's an operation that you don't want to screw up! I don't imagine
that there's any way to fix a mis-aligned web.

Since they were using a vertical shaper on the bores of the
crank webs, is it possible that they were splined so you could not get
them a little out of line? (Though the ends of the crank pins in the
photos did not obviously show signs of splining.) It could still be a
key on the side not visible to prevent misalignment.

Enjoy,
DoN.

--
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. | http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---