fl wrote:
Hi,
My electric oven does not work anymore. It is found that the heater
must be replaced. I purchase a heater element in nearby store. The
problem is that the two ends of the new element are separated than the
original one. Can I use tools to shape the two ends, i.e. to widen
their distance to about 1cm in order to install it? I worry about the
damage may incure.

If the proposed bending is spread over the element length, no worry.
If it consists of bending the last inch at 90 degrees, no

The second question is that anything to avoid
electric shock relating to the installment. What measures should check
after the replacement?

L&N to E resistance, should be o/c

Although I can repair normal applicance, I am
still concern the safety issure involved. Thanks.

Its on a fuse or MCB, the metal case is earthed with a chunky wire.
Its actually safer than most plug-in appliances shock-wise.


NT