Amigo108 wrote:
On Jun 1, 10:35 pm, TD Driver wrote:
Nutz. So I finally have something moderately productive to do with
this new $35 gadget. I've got a 3+ inch deep dado in a 4x4, the side
of which were cut on the bandsaw. And rather than chop out the
waste, I figured my new multitool would make short work of it. It
zapped thru the first half inch like the hot knife thru butter, then
the blade loosened. OK, I mustn't have torqued it enough. So for the
next 30 minutes, there was more in and out than I had on my wedding
night. A few seconds of cutting then the blade came loose. I finally
resorted to the old hammer and chisel. Multimaster? Not.

Any tips from any of you guys who went for the same deal?

Larry

Where did you find a Fein Multimaster for $35??

BTW, I need more blades right now, anyone know a good inexpensive
place to buy them online. None of my local suppliers carry them.


I believe the Dremel blades will fit.

HF has an assortment of blades for their tool. A five-pack is $6.95 or
thereabouts. They may fit your high-priced model.