"Oren" wrote in message
...
On Sun, 31 May 2009 19:18:59 -0600, "SteveB"
wrote:

They used a roller
for a stamp.

Steve,

Was there a rubber pad, with a pattern under the roller? The stamps
I've seen here, they use dense pads with the pattern and sometimes
tamping by hand to transfer the pattern onto the pad while still wet.

This was a cylinder about three feet wide by one foot in diameter, a shaft
through its center, with handles like a lawnmower. A very simple device.
The surface was made out of rubber, or something soft. I would suspect a
repeating pattern, but observed none.

Steve