I got the Delta and I like it except for one problem -- the turn table
is a few thousandths of an inch higher than the rest of the table. I
set the extension wing at the same height as the turn table and
haven't noticed any errors in my work because of it. However, I may
not be good enough for it to matter.

When considering cost, make sure you factor in a new blade. You will
need that with either saw.

Mark

"eric" wrote in message ...
I am looking to replace my Ridgid 12" miter saw with the delta 36-312 model,
I was considering the dewalt 705S but since both the delta and the dewalt
are the same price ~$299 and delta is now offering a $50 rebate I am leaning
towards delta, anybody seen / used the delta / dewalt models and care to
comment on either ?