On May 31, 3:10*am, "iwdplz" wrote:
I made a drawing of the two existing switches (link below). *With the setup
shown in this drawing, how would I hook up the Leviton switch/GFCI outlet
combo? *One of the existing switches is for some landscape flood lights, and
the other switch is for the in-ground pool light. *I'd like to swap out both
with GFCIs..

http://www.autonvs.com/images/poolswitches.jpg

Somthing does not look right for the landscape lights, There is only 1
wire going in and 1 wire going out on a different cable with no
neutral tied. Leads me to believe that the neutral comes from a
different source, maybe somewhere down the line in a junction box for
the landscape lights. In this case you can't use a GFI on the
landscape lights because it needs a hot and neutral. Unless you can
re-use that "cut" wire as the neutral, then you can use it. But lets
work on the pool lights.
It looks like the top middle cable is your 110V feed. So connect that
to the "Line" neutral and hot side of the GFI.( leave in the black
jumper going to the landscape lights)
Now connect the white wire of the pool circuit to the "LOAD" neutral
terminal. Take the black wire of the pool circuit and connect that to
one of the black switch wires of the GFCI/combo switch.
Now take the other switch wire of the GFCI combo switch and connect
that to the "LOAD" hot terminal.
Stupid question , but are these pool/landscape lights low voltage or
110V?