"iwdplz" wrote in message
...
I made a drawing of the two existing switches (link below). With the setup
shown in this drawing, how would I hook up the Leviton switch/GFCI outlet
combo? One of the existing switches is for some landscape flood lights,
and the other switch is for the in-ground pool light. I'd like to swap out
both with GFCIs..

http://www.autonvs.com/images/poolswitches.jpg


Nice drawing, however if it is accurate, you have no grounding conductors
and should disconnect it and replace the wiring. The landscape wiring has
the neutral cut off, so for it to work, some type of Rube Goldberg wiring
must have been done. To connect the pool light to a combo GFCI switch, You
connect the feed neutral to the "line" neutral on the device. Connect the
pool light neutral to the "load" neutral on the device. (Under the yellow
tape). Connect the pool light black to the "load" hot. Connect the feed hot
to one of the black wires on the device. Connect the other black wire on the
device to the "line" hot.