"Michael Koblic" wrote in message
...
How do you drill cross holes in small cylinders (brass or steel). The
cylinders are 3/8 - 1/2" in diameter and often less than 1" in length. The
hole is 1/4"

I am having all sorts of problems with this: The clamping is limited as
the clamps often interfere with the drill, especially centre drill. I find
it impossible to clamp both ends of the cylinder for the same reason. I
tried drill press vise, v-blocks, side-ways chucks, you name it.

What usually happens is that the part tends to flex somewhat and even if
it does not there is horrible chatter.

Some sort of sacrificial v-block? But the part still has to be held in it
somehow.

Ceramics clay and let dry to hold part, end mill to create flat spot, then
drill???

Some variation thereof.