muzician21 wrote:
Have a B&S on a 70's era Snapper 21" pusher with an aluminum deck. I
believe the engine is probably 10 years newer than the rest of the
mower.

Maybe 10 years ago I took it to a repair shop who installed a solid
state unit to replace the points. Even with the solid state ignition
it was never one-pull start, but as I recall it usually started with
probably 3 - 5 pulls. Now it takes probably 20 pulls or more and
monkeying with the throttle. Once it fires it runs like a clock, runs
up and down the speed range fine. It's also easier to re-start once
it's been running - though still not one pull. Doesn't seem to use an
inordinate amount of oil, no discernible smoke out the exhaust. It
gets what I'd call moderate use. I'm in central Florida so it gets run
bi-weekly or so during the rainy months, not at all during the months
of what passes for a winter down here.

I'm mechanically inclined but not well-versed on the theory of this
kind of engine. I've had it broken down far enough to remove and flush
the gas tank, change the points when it had points, replace the pull
rope. I've change the spark plug of course. I know it should start
much easier than it does. Any suggestions where to look, what to
tweak? There isn't that much to it from what I can see, so it
shouldn't be that difficult. I believe this mower has a lot of life
left in it.

Thanks for all input.
Sounds like it's time to do a little work on the carburetor. Put a new
diaphragm in it if it the older type that uses those. As the motors age
it's worth while to make a priming port in the air cleaner, drill a hole
you can plug after starting and spray some carb cleaner in it to start
it. Also check the valve clearances (those easy spin engine valve
clearances are pretty critical for easy starting) and a good spark plug.
Would help if you posted the engine model number. On newer ones
with primer bulbs and bowl/float it's common for the main jet to get
clogged over winter.