Should I get a 3 jaw chuck or a 4 jaw chuck for my dividing head?
On May 14, 8:25*am, " wrote:
Well I think that would work when using the dividing head horizontal.
Or you could center with the head horizontal and then rotate it to
vertical.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *Dan
The BS-0 could be aligned with a 1/2" rod in its MT2 center hole. If
your collet springs open a center finder point is convenient, it also
works with 5C collet blocks. But they are difficult to remove from
tight collets.
jsw
|