On Apr 19, 10:16*am, "Arfa Daily" wrote:
"Charon" wrote in message

...



I have a small circuit and I think I may have crossed something and
wrecked a transistor. I'm pretty much self teaching and want to see if
I have this figured out properly

I am fixing a small board that charges a battery and powers a device.
When the board is plugged in the output power works fine and the
device will function. The battery has charging voltage going to it
while plugged in.
When the board is not plugged in it will not power the device from
battery. I have traced the circuit. Between the battery and where the
power supply meet up there is only a resistor and a pnp transistor. If
I jump the collector and emitter on the PNP everything works as
expected and the device will receive power.

The PNP, only the C and E are soldered to anything, the Base is not
connected to anything. Why would this be ?

Doesn't electric charge flow on C and E if there is no flow on base ?

Did this transistor go bad ? if there is flow between C and E why
place this in a circuit ?

Just trying to figure out how this works and why only C and E of this
transistor are used ?

Thanks if anyone can shed some light on this for me.

What makes you think that the device in question is a PNP transistor ?
I tracked the part down to
http://www.diodes.com/datasheets/FZT789A.pdf
Silk screen on the part is FZT 789A

Does
it actually *have* a third leg that isn't connected anywhere ? The reason I
ask this is that there is a range of wire-ended fuses which are in a TO92
package, just like a transistor, but they physically have only two legs at
the two 'corners' or the package. These devices are typically marked "Nx"
such as "N10" for instance. What is the descriptor silk screened on the PCB
for this device ? If it really is a transistor, it is likely to be something
like "Qx" or "Trx", but if it is a fuse of this type, it will likely be
"ICPx"

Arfa

The transistor is only connected on the E and the C (tab) the other
two are not connected to anything.