On Wed, 25 Mar 2009 18:01:12 -0800, David Nebenzahl
wrote:

On 3/25/2009 10:24 AM PlainBill spake thus:

Contrary to what several nay-sayers have expressed, this exercise has
a LOT to do with electronics repair. Any fool can keep replacing
components until he finds the bad one. The successful tech will be
able to analyse a circuit and make meaningful tests to identfy the
failing part.

Thank you. It's more than a little annoying being completely written off
as a clueless idiot simply because I reversed a diode's polarity *in a
schematic* (since corrected).

NOW your next exercise is to identify the values for these components.


I'd love to oblige you; unfortunately, I'm not yet at that level. I know
Ohm's law and some other basic stuff, but not enough about circuit
design to assign values with any confidence. I look forward to others
doing that. And someday, I intend to get a good basic electronics
textbook and seriously study it ...

Several comments on this circuit. First of all, it could work, but
would require significant improvements, some of which have already
been discussed. Rather than using a doorbell or chime, a Sonalert
could be used. In part this will depend on the sound level desired.

Second, some of the criticisms are valid. If you intend to do this as
a design exercise you can have fun designing it, but I would not
recommend building it. You are dealing with potentially lethal
voltages, and fairly expensive components to withstand those voltages.

IMHO, you are using the wrong approach. Over 30 years ago I built
something similar using a few small caps, a few resistors, a diode, a
speaker, and a 74C914 hex schmidt trigger. I used 4 AA cells to power
it, your application should use a 'wall wart' putting out 6VDC at 100
ma. I'd have to look up the specs, but a 555 timer would also do the
job.

PlainBill