Thread
:
Recasting a broken small nylon gear
View Single Post
#
14
Posted to sci.electronics.repair,sci.electronics.design
msg
external usenet poster
Posts: 412
Recasting a broken small nylon gear
wrote:
On Mon, 16 Mar 2009 13:19:57 -0600, msg wrote:
I needed to repair an Exabyte 8505 8mm tape drive which had a broken 14 tooth
approx 3/8 inch diameter nylon gear in the cartridge handling mechanism, and
lacking suitable spares, I decided to attempt to reform the gear; this post
describes the method and results.
Gear sizes are standardized. It would be easier to find the raw
spur gear stock and re-machine the bore and length to suit your
purpose. Check the "Machinery's Handbook" for sizes.
It would indeed by nice to have a variety of standard nylon gear stock
on hand; has anyone found a cheap source for such kits?
Michael
Reply With Quote
msg
View Public Profile
Find all posts by msg