View Single Post
  #9   Report Post  
Posted to uk.d-i-y
tony sayer tony sayer is offline
external usenet poster
 
Posts: 6,896
Default Satellite alignment. Got Astra 1 but want Astra 2

In article , Steve
scribeth thus
Steve" wrote in message
...
Hi. I'm new to satellites and am doing a DIY installation.

I'm having problems aligning my new dish and wondered if anyone can
advise. I get very strong signals from Astra 1F at 19.2E and Astra 1E at
23.5E with the same dish position - loads of channels. Signal strength
and quality are about 80% for both 1F and 1E.
cut
But I want 'Astra 2' at 28.2E and can't find it. My satellite-finder
meter give a very strong signal for the Astra 1s but reducing the
elevation and going east a few degrees gives only a weak signal the
receiver doesn't recognise.

cut
Steve


Thanks for the replies all.
To answer some of the points, I have plenty elevation (over 20deg over the
garage roof) from the dish to where I believe Astra2 is - the line of site
is unobstructed,. My suspicion about the 'thermal radiation' from the
garage roof arises because of the LNB offset: the LNB is well below the
dish's axis, so the line of site is well above the dish's axis, but the
dish's axis points towards the garage roof.
I'm using a hand-held satellite finder with a built-in meter and audible
signal, the thing 'screams' when pointing at Astra 1 but nothing for where I
believe Astra 2 is. And I do get both Astra1s (19.2 and 23.5) strongly from
the same dish position!
Oh well, will try again tomorrow.
Thanks again.
Steve


What's this ASTRA 1 at 23.5 then?...
--
Tony Sayer