On Mar 10, 12:30*pm, "Bob La Londe" wrote:
Most shops I have seen use iron pipe for air, but I was just looking at a
couple on-line specs sheets on PVC and it looks like if I were to distribute
air at 125 PSI in my shop using 1" Schedule 40 PVC I would have about a 30%
safety margin at the worst case scenario. *That's based on 120F operating
temperature. *While yes it does hit 120F here in the desert once in a great
while I don't think its ever gotten above 105 in the shop building. *Better
safe than sorry though.

Wadda ya think?

P.S. *I have seen other shops use PVC also, and they said they never had any
problems.

The only real issue I see is that "wish this hose was 2 inches longer"
factor. *I could probably mitigate that by using brass fittings at the ends
and securing them properly at the wall, and of course the fact that there
would be air all over the shop instead of in one corner would help quite a
lot.

Not regarded as a good idea.

http://www.osha.gov/dts/hib/hib_data/hib19880520.html

http://www.hotrodders.com/forum/pvc-...es-108824.html

Gets brittle, fractures, plenty of sharp high-velocity shards.


Dave