View Single Post
  #3   Report Post  
Posted to rec.crafts.metalworking
Don Young Don Young is offline
external usenet poster
 
Posts: 674
Default Bridgeport Quill Spring


"Wayne" wrote in message
...
Don Young presented the following explanation :
"steamer" wrote in message
...
--Well I've got it back in the quill but I'll be damned if I can
figure out how to add the 1-1/2 turns of pretension. Every time I rotate
the
collar the spring goes about 1/4 turn, then snaps loose and needs to be
retensioned. Sooo what am I doing wrong?

-- "Steamboat Ed" Haas : Do us a favor and rescue
Hacking the Trailing Edge! : a doggie or three...
www.nmpproducts.com
---Decks a-wash in a sea of words---

This is not unusual. You may have to renew or rework the offending pin.
The inner end of the spring has to be curled fairly closely to hold good
and the outer pin tends to get pushed into the housing too far. Your
spring may not be hooked on the outer pin as this will allow the spring
to slide around when it is tightened a little. Do not try to tighten the
spring until it retracts the quill. It is intended only to keep it from
falling and may not do that if you have a heavy tool in the spindle.

Don Young


Don Young


I thought my quill was mis-adjusted since it didn't retract. It never
bothered me enough and figured I'd get to it one day. Now I know it's
working properly and I don't have to do anything with it.

Thanks,
Wayne D.


From what I have read in various groups and forums that is a very common
misconception. That is why I mentioned it. That is also probably one of the
reasons so many of the springs break, since they can reach the limit of
their travel when over-tightened.

Don Young