On Sat, 21 Feb 2009 19:43:04 -0500, "Stormin Mormon"
wrote:

Did you wire brush off the visible rust, first?

Howdy,

No, but there was no way I could, and that was a big part of
the problem:

When the yoke was fully on the shaft, the end of the shaft
was flush with the yoke. There was nothing exposed to brush
(until I got the yoke off completely.)

Once I got it off, I polished the shaft with fine abrasive
paper, coated it with anti-seize, and pushed the yoke by
hand.

All the best,
--
Kenneth

If you email... Please remove the "SPAMLESS."