Robert11 wrote:
Hello,

Have the typical Watts Pressure reducing valve on the incoming line for my
house water.

It's hard to read the label, but I think it is a model USB Z3
Range is given as 25-75 psi

Town says the incoming line pressure is about 70 psi.
Reducer was set at the factory for an outlet p of 50 psi.

Looked on the Watts site but they seem to have every spec but this one.

Anyone know the scale factor for how much the outlet pressure would be
increased
for, e.g., 1 full turn of the adj. screw ?

Thanks,
Bob


A gage is the only real way to tell. Not sure why corners are cut when
installing regulators. All it takes is to sweat in a tee and attach a gage.