In article ,
Appelation Controlee wrote:
A while ago - probably a couple of years - I bought one of the
Performance Power bench drills that were on special at B&Q. It's only
this week that, with a job to do that needs a modest amount of
precision, I've finally erected and sited it. It will be fine for what I
want (the current project will justify the cost on its own) and I'll get
by for immediate purposes with general purpose clamps to position and
hold the itemas I'll be working on, but I've realised that the tool will
be all the better for a jig arrangement of some kind to fit on the
worktable to facilitate workpiece positioning. A cursory spin through
Toolstation and Screwfix reveals nothing that will fill the bill. What
should I be looking for, and where should I be looking? I want one or
more jigs that will provide a reasonable capability, without being
specialised. Any/all suggestions will be most welcome. :-)

Drill press vice?

http://www.screwfix.com/cats/A435622...ll-Press-Vices

--
*Caution: I drive like you do.

Dave Plowman London SW
To e-mail, change noise into sound.