Furnace burners won't ignite
On Jan 20, 9:37�pm, rocketman wrote:
I have an Amana GHN90A50 furnace (circa 1987) that has an ignition
problem: I will occasionally notice the house is cold, with the temp
well below the setting on the thermostat. �When I check the furnace,
the blower is running, the ignitor is glowing but no ignition. �If I
then set the thermostat lower than the room temp, the blower and
ignitor shut off. �I wait a few seconds (which I guess allows the
furnace to reset) and raise the temp on the thermostat. �Then
everything is fine: the blower and ignitor come on and the burners
ignite.
I have a suspicion that this only happens (and then, only
occasionally) when we set the thermostat low for the night (60 or 61
degrees) but I have not tested this theory. �Strangely, our tenants in
a house we rent had the same problem with a new furnace we installed
there a year ago; they set it low (maybe 55 degrees) because they were
out for a few days and found that the furnace didn't ignite.
Any suggestions?
sounds like a bad ignitor, when the last time the furnace was serviced?
|