Drill bit sharpener
In article , Phil Again
wrote:
Joe:
What size drill bits have you been successful sharpening? My most common
drill bit sizes I need sharpening are all under 3/16" inch; 1/8 inch,
down to wire size drill bits. I know the Drill doctor probably ain't
going to sharpen no #58 drill, but I would like to know just how small a
drill the Drill Doctor will go.
(I use these small drills as pilot holes for scroll saw work.)
Thanks in Advance
Phil
Phil,
The 500x will sharpen any bit from 3/32" up to 1/2". The 750x will do
up to 3/4".
I liked the 500x so much that, after I started using it, I ordered the
bit chuck that would take up to 3/4". Basically, what I did, was to
turn my 500 into a 750.
I especially like the split point feature on the larger bits. It does
help to keep them from walking away from the starting point.
Joe
aka 10x
|