CC:

Just beware that the Quickset knives from Jet/Powermatic
are unique. I found that no one else makes a replacement
set and you have to order them from Jet/Powermatic.

I have the Powermatic version of this jointer and overall
it's a good one. The table is NOT superflat and I have
been trying, without a lot of push or success, to get
them to tell me what their tolerances are. But from
what my woodworker mentor tells me, it should
be just fine.

If you could find one that was in the store and buy it off the floor,
you'll be able to measure the flatness.

MJM