"N_Cook" wrote in message
...
lagagnon wrote in message
...
I have a Yamaha RX-596 stereo receiver, which has small ?servo motors
that enable remote control of both the volume control and the source
input (phono, cd, tape, etc) selector switch knob. The ?servo motor or
its
circuitry which moves the source selector knob seems to have a
problem: it often bypasses the chosen position, or it shimmys and
never settles to its correct position. When I operate the knob by hand
(rather than with the remote) I can put it in its correct place but
sometimes the LED display showing CD of FM or Phono will lag or
flicker.

It seems to me that there is some bad connection somewhere, or an
offset between the servo control postition and the rotary contacts.
The switch and its motor circuitry are fairly easy to get at inside
the receiver
cabinet, so I am considering at least pulling the cabinet off and
having a look and possibly reparing it mysefl - if this is at all
possible?

Any ideas on experiences with a similar problem and what it might be
would be greatly appreciated.

Thanks!

Larry Gagnon


I cant help you here except to say I have the same issue with my unit.
It rarely does it though but still annoys the crap out of me.

Mark