On Jan 2, 11:07*pm, "Cash"
wrote:
Yekal wrote:
On Jan 2, 9:21 pm, YAPH wrote:
On Fri, 02 Jan 2009 10:55:10 -0800, yekal_tytwr wrote:
Hi All,
We are building a house with wet underfloor heating which goes back
to 2 control units, which have all the wiring completed, only
leaving 2 wires from each unit going back to the boiler (volt
free). the boiler has now been installed (Worcester Greenstar 12/18)
Is that an oil boiler? I don't recognise the model name as a gas one.
*Yes this is an oil condensing boiler
... which I
could not find any volt free connections, I spoke with Worcester
bosch technical today and all they could tell me was that the
boiler doesn`t have the appropriate connections, but could not tell
me how I could resolve this problem.
Anyone shed any light???.
Not sure what your UFH control units require. You say they want
volt-free connections but not whether the connection is a signal
from the boiler to the UFH controller or the other way. If the
former maybe the UFH controller has its own mains power for its pump
and just needs a contact closure to tell it to run the pump. In that
case I'd be thinking along
the lines of fitting a pipe thermostat to the boiler's flow pipe to
tell the UFH when there's heat coming from the boiler.
Alternatively if the volt-free connection is a signal /from/ the UFH
controller /to/ the boiler from a set of contacts in the controller,
then I'd think along the lines of connecting across the boiler's LS
and LR terminals.
I think you really need to scan and post the UFH instructions
somewhere for us all to see (or point us to the mfr's docs online).
thanks for your reply , I can`t work out if it is possible to post the
wiring diagrams on here, would you *mind if I email them to you?.
--
John Stumbles --http://yaph.co.uk
A: Because it messes up the order in which people read text.
Q: Why is top-posting a bad thing?
Scan - or photograph the picture[s] using a digital camera and upload them
towww.tinypic.com, give a 'Tag' (or name) and then post the IMG Code for
Forums & Message Boards link to the group. *Example below (it works if you
want to view the image):
*Note: leave out the [IMG]
either side and post link thus:
http://i44.tinypic.com/25gavxt.jpg- note the coloured and underlined text
that indicates a valid link.
Hope this helps
Cash- Hide quoted text -
- Show quoted text -
Thanks for all that, I will give it a go fingers crossed!!
http://i40.tinypic.com/2eund40.jpg this one is the boiler wiring
diagram
http://i44.tinypic.com/303e4c7.jpg and this should be heating
diagram
this link has not gone blue as yours hopefully it will appear blue
when I post, well here we go!