Strands drill press
On Mon, 29 Dec 2008 11:24:37 -0500, Karl Townsend
wrote:
On Mon, 29 Dec 2008 09:01:31 -0600, "Robert Swinney"
wrote:
Press the bearing out and take it to a bearing supply house for replacement. They are "standard"
and you should have no problems dupeing bearings and belts as necessary. A Phase-O-Matic 'TM' will
start and run your motor quite nicely. Just be sure to buy one for the rated HP of the drill's
motor.
Better yet, get a VFD for your drill press. About the same cost, but
you get variable speed. A very handy addition to any drill press.
Karl
Seconded.
Is that Strands a post drill?
Gunner
"Upon Roosevelt's death in 1945, H. L. Mencken predicted in his diary
that Roosevelt would be remembered as a great president, "maybe even
alongside Washington and Lincoln," opining that Roosevelt "had every
quality that morons esteem in their heroes.""
|