On Sun, 14 Dec 2008 08:58:57 -0000, N_Cook wrote:
David Farber wrote in message
...
N_Cook wrote:
David Farber wrote in message
...
"N_Cook" wrote in message
...
Will rewind 90 percent of a 4 hour tape in 40 seconds or so and 20s
for the
remainder.
What would allow the motor to run at full tilt ? clunking loudly to
a stop.
If it was not for the "crumple zone" of tape pulled into the gap
between tape roll and spool disc then the tape would have snapped
at the end of tape.
What to look for in the way of a problem ?
System presumably monitors ratio of supply and take up rotation
rate and direction of wind and unlaces tape from drum and over 3
stepped increases ,
sets at maximum revs until the ratio goes over a preset value and
drops by stages to a slow rate until end of tape sensor acts.
--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/
I'm not exactly sure what you're saying is the fault. Is it that the
motor is going too fast and/or it is making a clunking noise near
the end of the tape? Newer VCR's do bump up the rewind speed after
several seconds to but I think you know that already. Is the machine
damaging the tape?
--
David Farber
David Farber's Service Center
L.A., CA
It should recognize getting close to the end of tape and start
reducing the power / revs of the motor but it once continued at full
revs to the end of tape. Been monitored by human since it happened.
It does not speed up if human stops the motor close to end, goes
normal speed to the normal clear tape auto stop if REW is engaged
again ofter pre-emptive stop.
I'm thinking a break in the line from the fast , take up spool
sensor, so less pulses coming from it and false interpretation.
Does the same thing happen when you fast forward to the end of the tape?
--
David Farber
David Farber's Service Center
L.A., CA
Taking the cover off and visually monitoring the amount of tape left, the
VCR works fine FF or REW . Going up to express rate and back down , in
either direction, as long as there is plenty of tape run..
It just once , so far, spectacularly failed.
Are your tapes that impotant to you? If it only does it once in a blue moon, who cares?
P.S. mine (a Samsung) does the same thing about 1 in 30 times, but 20 minutes from the start of the tape. It appears to panic thinking it's about to hit the end and had forgotten to slow down. It goes straight from full speed rewind to stop, and I have to press rewind again to rewind the remainder of the tape.
Nevermind, once I've watched my backlog of tapes, I'll be giving it away. I've got a Sky HD box (built in hard disk recorder) which I upgraded to a terrabyte :-)
--
http://www.petersparrots.com http://www.insanevideoclips.com http://www.petersphotos.com
Los Angeles's full name is €śEl Pueblo de Nuestra Senora la
Reina de los Angeles de Porciuncula€ť and can be
abbreviated to 3.63% of its size, €śL.A.€ť