On Thu, 18 Dec 2008 13:02:20 UTC, Mike Harrison
wrote:

I'm looking for a 5.5mm nut driver bit with a standard hex-drive shaft, for doing up M3 nuts.

For some bizarre reason all the sets I've found typically have 5mm and 6mm but not 5.5mm - the
latter must be more commonly needed then 5mm, which AFAIK is only used for M3 threaded spacers and D
connector jackscrews....

Anyone found a 5.5mm in a set anywhere?

For years now I've been using a 1/4 inch square drive socket fixed to
the end of a 1/4 inch screwdriver style handle. Dedicated - the two
never part company!

--
The information contained in this post is copyright the
poster, and specifically may not be published in, or used by
http://www.diybanter.com